Insulation Grant Program

Acoustical Testing Plan - Message Board

 

Do you have an ATP question, please email SIGP@lawa.org

 

Questions and Answers


Question:

The table shows exterior CNEL and interior CNEL reported as whole numbers (i.e. 70) while the average interior DNL numbers is reported with a single decimal point (i.e. 45.2). It seems odd to use whole numbers and then report the average with a decimal point. My question is, should they all be reported as whole numbers, or all with a decimal point, or at a minimum mentioned that they are calculated with a decimal point but rounded to a whole number for reporting purposes?

Answer:

The recommendation is that tenths of a dB be used for calculation purposes, but that the resulting average interior noise level be reported as a whole number. The table of results can present whole numbers everywhere, but have the reports note that tenth of a dB was used in the calculations and that they were rounded to whole numbers for reporting purposes.


Question:

Is the revised ATP dated October 14, 2015 the latest version available?

Answer:

Yes



Question:

Page 10, paragraph 1 – we assume the reference to the ASTM E966 correction should be stated as -5 dB, not -3 dB, for the flush method?


Answer:

Yes, the ASTM E966 correction should be -5dB for the flush method.


Question:

Can you direct me to the correct NEMs to use to determine the exterior CNEL for all tested properties?


Answer:

The new NEM is on the LAWA website. We can also email a Shape file.



Back To Top